Home  >>  News

Ice Making Process of Flake Ice Machine 2 Tons

Jun. 25, 2019
Share:

(1) Before starting the Flake Ice Machine 2 Tons, it is necessary to check whether the automatic water supply device is normal, and whether the water storage capacity of the water tank is reasonable (the water level has been adjusted when the machine is shipped from the factory, the user may not adjust the water).

(2) Plug in the power supply and the ice machine starts working. First, the pump starts running (the pump has a short air exhaust process). After about 2 minutes, the compressor starts to start and the machine enters the ice making state.

(3) When the thickness of the ice cube reaches the set thickness, the ice plate probe starts to start, the solenoid valve starts to work, the water pump stops working, and the hot gas enters the evaporator, and the ice cube falls about 1.5 minutes. When the ice cubes fall, flip the ice tray and open the reed switch. When the reed switch is reclosed, the machine enters another ice making process.

(4) The compressor does not stop during the whole process of ice making and deicing.

(5) When the ice storage tank is full of ice and the reed switch cannot be automatically closed, the machine automatically stops working. When enough ice is removed and the reed switch is reclosed, the machine starts after 3 minutes delay and re-enters the system. Ice process.

Flake Ice Machine 2 Tons

Contact Us
Follow Us